Manual
4130 Pager
©
Commtech
Wireless
Page
7
3.1.3
Replacing the Battery
The pager will warn you when the battery is getting low within the unit by displaying the
battery low icon on the LCD screen described above. The pager is powered by a single
alkaline battery. Follow these directions to replace the battery:
▲
WARNING: Before removing the battery, make sure the pager is turned OFF. Removing the
battery while the power is ON can corrupt or delete data. If you do not wish to use the pager for a
long time, write down any important data stored in the pager and remove the battery.
1.
Turn the pager off. (see the directions on this later on in this manual)
2.
Slide up the battery compartment lock on the pager case.
3.
Remove the battery compartment cover by sliding it in the direction of the
marked arrow.
4.
Remove the exhausted battery and replace it with a fresh alkaline battery.
IMPORTANT: If you replace the batteries quickly, stored messages, settings and the time/date
will be retained.
5.
Re-attach the battery compartment and return the lock to its original position.
3.1.4
Turning the Pager “ON”
To turn the pager ON, follow these steps:
1.
Inserting the battery into the pager will turn it on.
2.
If the battery is already in the pager, press and the hold the
Read Key
for two
seconds. The pager may beep and/or vibrate depending on the current alert
settings in the pager. The LCD screen will also activate to show that it is working
properly. This initialization lasts for several seconds and can be cancelled by
pressing any of the buttons on the pager. After the initialization is complete, the
pager will display a start-up message for two seconds, if this has been
programmed in. After the start-up message has been displayed, you will be at the
Standby Screen
. The
Standby Screen
shows the current date and time.
3.1.5
Turning the Pager “OFF”
1.
Go to the
Standby Screen
.
2.
Press the
Menu Key
to display the
Settings Menu
.
3.
Using the
Menu Key,
scroll through the
Settings Menu
until
Pager Off
is
found.
4.
Press the
Read Key
to confirm the selection.
