860508548
Instruction Sheet
www.commscope.com
Orange pair
Blue pair
Green pair
Brown pair
Ensure that front pairs
are tightly routed
6. (T568B wiring shown) On the
Reverse
cable end, pull Green and Brown pairs back, eliminate the twist, and
pull them tightly into place. Then route Orange and Blue pairs to the front positions.
Note: For T568A Wiring
-
On each cable end, one of the two pairs fed in through the holes is pulled back for the rear positions. Check
label color codes.
Conductor Seating and Cutting
Impact tool on HI setting
with M110 cutting blade
Hand puck
Pliers
Trim pairs
flush
Fine edge
cutters
1. Use impact tool on HI setting with M110
cutting blade to punch conductors
straight down into slots. When using the
impact tool, the hand puck is
recommended.
Or
2. Use pliers with wire cap to seat
conductors. Use fine edge cutters to
trim conductors flush to the module
body.
Page 4 of 5
