860610260
Instruction Sheet
www.commscope.com
Page 4 of 5
Alternate Mounting Method
4. An alternate method for mounting involves sliding the
imPower
onto the farthest left cable management bar
for the
imVision
controller as shown.
Step 3
– Connect Ribbonized Jumper Cables to Controller and Panel Bus
Note:
imPower
connections will replace existing data and power connections for installed
imVision
controllers.
Disconnect female 10-pin connector from panel bus, removing jumper.
1. Ribbonized jumper cables transmit data communication through the controller and panel bus.
The 10-pin jumper cable terminates at the
imVision
controller 14-pin panel bus port.
The 16-pin panel bus jumper cable female 10-pin connector plugs into the panel bus port closest to
center of panel bus, as shown below. Loose jumper cable can be inserted in the two adhesive clips on
bottom of controller. Insert
panel bus jumper’s additional 10-pin male connector onto panel bus strip for
additional capacity.
Note:
For proper system function, it is imperative that the panel bus jumper cable is plugged at the middle of the
panel bus. Other locations (higher or lower on panel bus) could result in unreliable communications between the
imVision
controller and the
iPatch
panels that are installed on the panel bus.
PWR 2
PWR 1
Panel Bus
PWR
2
PWR 1
OUT
Outlet
imVision
controller
imPower
14-pin port
10-pin
female
connector
16-pin long
jumper cable
10-pin short
jumper cable
PWR1
Power jumper cable
Out
10-pin
male connector
Panel bus
Slot on
used
for alternate mounting
imPower
imPower
