• 902-2001-0000 E510 Antenna Cable (150 cm length)
• 902-2002-0000 E510 Antenna Cable (300 cm length)
CAUTION! If third-party RF cables are used, the customer is
responsible for entering the correct signal loss profile /
antenna gain in the SmartZone GUI.
Mounting Bracket
The E510 AP Module Mounting Bracket (RUCKUS PN#
902-2004-0000) must be purchased separately for mounting the
AP Module to a pole. The pole mounting bracket kit includes the
following:
• Pole mount bracket
• 3 M4x8mm bracket screws with built-in lock washers and flat
washers
• 4 metal pole clamps
M8 and M12 Connectors
If third-party Ethernet or DC power cables are used, the installer
must ensure the proper cable connectors are used. The following
are examples of third-party cable connectors that can be used
with the E510:
• M12 X-coded 8 position PoE connector:
• M8 A-coded 3 position connector:
Mounting Instructions
Mounting Scenarios
The E510 is designed for embedded mounting into third-party
structures such as light poles, light fixtures, street furniture,
railway carriages and track side installations.
Surface Mounting
The AP Module supports mounting on a flat surface into which
holes can be drilled.
Use customer-supplied hardware to mount the AP Module to a
flat surface.
FIGURE 2 E510 AP Module flat surface mounting flanges
Pole Mounting
The E510 AP Module can be mounted on a pole with the E510 AP
Module Mounting Bracket (PN# 902-2004-0000).
NOTE: The included hose clamps can support a pole diameter
up to 120mm, when daisy-chained together.
1. Attach the mounting bracket to the AP Module using the
three M4 bracket screws with built-in flat washers and lock
washers included in the bracket kit. Torque screws to 20 in-
lbs (2.26 Nm).
NOTE: The AP Module can be mounted either flat to the
pole or side-mounted. The bracket provides holes to
accommodate both scenarios. Side mounting uses three
screws and flat mounting uses two screws.
FIGURE 3 Attaching the bracket to the side of the AP
FIGURE 4 Attaching the bracket to the back of the AP
2. Use the two metal pole clamps to attach the bracket to the
pole. Tighten pole clamp screws to 27 in-lbs. (3.05 Nm).
Copyright
©
2020 CommScope, Inc. All rights reserved.
Page 2 of 4
Published June 2020, Part Number 800-71577-001 Rev D
