4. Commissioning
Page 24
M0200AJA_ION-U_EU_L_17EP_17EP.docx
User’s Manual for ION
®
-U
5.
Notice:
If any different or additional mounting material is used, ensure that the
mounting remains as safe as the mounting designed by the manufacturer. The
specifications for stationary use of the Unit must not be exceeded. Ensure that the
static and dynamic strengths are adequate for the environmental conditions of the
site. The mounting itself must not vibrate, swing or move in any way that might
cause damage to the Unit.
Specified torques must be observed for certain mounting procedures according to the
following table:
Type
Pins
Hex nuts Screws
Thread
M 6
M 6
M6
Specified torques
3.3 N-m
3.3 N-m
3.3 N-m
table 4-1 Specified torques
4.1.3. Mounting bracket
4.1.3.1. Mount to a wall
1. Check the suitability of the wall-mounting kit and the wall.
2. Install the mounting bracket using 4 M6 screw anchors (not included*) or suitable
lag bolts according to the drilling layout. Confirm that the bracket is securely
fastened to the wall. Installer must verify that the supporting surface will safely
support the combined load of the electronic equipment and all attached hardware
and components.
* The M6 screw anchors are not included as part of the EU delivery because the suitable type
depends on the on-site conditions (wall structure and materials). Use screw anchors that are
appropriate for the mounting surface.
figure 4-1 Mounting bracket
Summary of Contents for ION-U EU L 17EP/17EP
Page 1: ...ION U ION U EU L 17EP 17EP User s Manual M0200AJA ...
Page 66: ......
