Visit www.commscope.com for complete specifications on all the products listed
Bulletin # 7689527 Rev. G
Technical Publication
11
Connectors and Adapter cleaning
Clean exposed connector ferrule by lightly moistening lint-free wipe with fiber optic cleaning solution (or >91%
isopropyl alcohol), and by applying medium pressure, first wipe against wet area and then onto dry area to clean
potential residue from end face. Clean connector ferrule inside adapter by inserting lightly moistened cleaning stick
with fiber optic cleaning solution (or >91% isopropyl alcohol) inside the adapter until contact is made with connector on
opposite end. Rotate cleaning stick with medium pressure in one circular motion as it is pulled away from the adapter.
Repeat process using dry cleaning stick.
Caution:
Signal strength will be affected if end and sides of ferrule are not thoroughly cleaned. Discard cleaning
sticks after each use. Do not turn cleaning sticks back and forth pressing against connector end face. This may cause
scratches if large contamination is present. Always inspect connector end face for contamination after each cleaning.
Clean adapter by inserting adapter cleaning stick (or fiber adapter sleeve brush) moistened with fiber optic cleaning
solution (or >91% isopropyl alcohol) inside the adapter and gently pull out with twisting motion. Repeat process with a
dry cleaning stick.
Caution:
Do not try to clean adapter with a standard pipe cleaner. The sleeve inner diameter of adapters could be too
small. Do not try to clean the adapter with cleaning stick if a connector is mounted in one side. Discard cleaning sticks
after each use.
Clean Tip of Ferrule
Clean Sides of Ferrule
Adapter Brush
Section 7: Breakout Procedure
Remove electrical tape
from the trunk cable and
corrugated protection
tube
While holding the protection tube straight
pull the tube away from cable.
After you have pulled the fiber and power
conductors remove electrical tape from the trunk
cable and remove clear tube for access to all
optical connectors.
After the trunk cable has been installed and
you are ready to make the final connection
to the RRU or BBU follow these steps for the
removal of fiber protection tube.
1
2
3
