3
4.5
Incoming cable with a diameter Ø > 6.5 mm is secured with
the external strain relief.
Slide the strain relief until it clicks into place. The arrow on the strain
relief should point towards the termination side of the cable.
4.3
Align the box with the wall mounted base plate and slide the
box downwards until the snap hook of the box engages with the hole in
the base plate.
A
Incoming cable with a diameter Ø 7 – 14 mm
4.4
To release the box, push the snap hook as shown
100 mm
4.6
Adjust the cable with the base plate and mark the cable jacket
5mm below the edge of the base plate. Strip the cable jacket. Then
strip the inner tube at the length of 100mm from the end of the cable
jacket.
4.7
Secure the fiber tube of the cable loosely with tie wrap. Secure
the screw of the strain relief.
