ADCP-90-516 • Rev B • April 2019
Page 17
© 2019, CommScope, Inc.
8. Carefully rotate storage disk assembly (see
) to take up excess length. Finger
holes are provided to facilitate rotation of disk assembly.
9. As storage disk assembly is rotated, carefully guide patch cord slack into disk assembly to
prevent kinks from forming.
10. When all slack is taken up, push storage disk assembly slowly into chassis. Rotate disk
assembly as it is pushed into chassis to take up any additional slack that forms.
Figure 13. Routing Patch Cord through Disk Assembly
11. Push inward on the end of each snap tab until tab snaps closed.
12. Complete a designation label for the stored patch cord and apply label to front edge of
storage disk assembly.
13. Repeat procedure for each patch cord to be stored. Close front cover when complete.
14. When opening a storage disk assembly that is storing a patch cord, rotate disk assembly to
feed out slack as disk assembly is withdrawn from the chassis.
5.3
Using the Storage Tray Panel
Use the following procedure to store excess patch cord length in a Storage Tray Panel:
1. Adjust patch cord slack so that excess length is accumulated at the storage panel.
2. Open panel front cover and select storage tray assembly that will be used to store the
excess patch cord length.
3. Each tray is hinged on the left. Pull outward on the extended tab located on the right hand
corner of the tray assembly until tray swings open.
4. Swing storage tray assembly out of the chassis by pulling outward on the extended tab.
6728-B
MID-POINT OF LOOP
MID-POINT OF LOOP
PATCH CORD ROUTED FROM
LEFT SIDE
PATCH CORD ROUTED FROM
RIGHT SIDE
ROTATE TO
REMOVE SLACK
ROTATE TO
REMOVE SLACK
