ADCP-96-167 • Issue 5 • July 2016
Page 69
© 2016, CommScope, Inc.
11 MAINTENANCE AND REPAIR PROCEDURES
The Mini FDH 3000 cabinet requires no regular maintenance to insure continuous and
satisfactory operation. Maintenance is limited to repairing or replacing any cabinet
components that may be damaged or broken in the course of normal operation. The
following sections provide procedures for repairing or replacing common cabinet
components.
11.1 Painting
Brush-in-cap type bottles of paint are available for touching-up nicks and scratches in
the factory coat of paint. Lightly sand the area to be painted and then clean it
thoroughly to remove any dirt, dust, or foreign matter. Shake the paint bottle until
thoroughly mixed and then apply a light coat of paint to the damaged area using the
small brush attached to the cap. Wait until the paint is dry and then apply a second coat
if necessary. When finished painting, replace the paint bottle cap and tighten securely.
The catalog number for the paint kit is ACE-ACC-PTALMD.
11.2 Distribution Adapter Pack Replacement
Replacement adapter packs are available for the distribution sliding adapter packs.
Use the following procedure to remove and replace an adapter pack with a damaged
adapter:
1. Locate the sliding adapter pack with the damaged adapter as shown in
.
Figure 65. Removing a Damaged Sliding Adapter Pack
1. PULL UPWARD ON
TAB AND LIFT TO
RAISED POSITION
2.PRESS LATCH
AND REMOVE
ADAPTER PACK
FROM SLIDE
ASSEMLY
SLIDE
ASSEMBLY
DISTRIBUTION
CONNECTOR
SPLITTER
CONNECTOR
SLIDING
ADAPTER
PACK
24284-A
