860576982
Instruction Sheet
www.commscope.com
Page 2 of 7
Separately Orderable Components
Part No.
Description
PC-AUS-120-250
Engine power cord for Australia, New Zealand: 15A, 250 VAC, 3.6m
PC-BRAZIL
Engine power cord for Brazil: 10 A, 250 VAC, 2.5m
PC-CHINA
Engine power cord for China: 16 A, 250 VAC, 3.0m
PC-DENMARK
Engine power cord for Denmark: 16 A, 250 VAC, 2.5m
PC-EU-120-250
Engine power cord for Europe: 16 A, 250 VAC, 3.0m
PC-INDIA
Power cord for India: 16 A, 250 VAC, 2.5m
PC-NA-250
Engine power cord for United States, Canada, and Mexico: 20 A, 250 VAC, 10 ft
PC-SWISS
Engine power cord for Switzerland: 10 A, 250 VAC, 25m
PC-UK-120-250
Engine power cord for United Kingdom, Hong Kong, Singapore: 13 A, 250 VAC, 3.0m
TRM-RJ45-EU
RJ45 to 18AWG Terminator , per channel
Important Notes and Recommendations
For installations in Canada, no un-insulated live parts in the output from the
Redwood
engine shall be
readily accessible, as defined by the Canadian Electrical Code (CES). Accessibility shall be determined
using the risk of shock accessibility criteria such as use of the finger probe from the CSA standard(s)
cited for the category associated with the c-UL Mark.
Access to such parts should also be considered when removing panels that do not require the use of
tools when removed. Insulated parts, such as wire or cabling with outer insulation or jacket that are
certified and carry a sufficient voltage rating (>60V) are permitted to be accessible to contact.
If a fixture requires more than one channel for power, use additional wiring (see each fixture’s
specification for requirements). Note that all additional channels for a 2- or 3-channel fixture must be
connected to the same engine. Wiring for an individual fixture cannot be spread across multiple engines.
It is recommended that the fixtures in a single space be interleaved across engines. This provides
another level of redundancy
— in the event of an electrical failure affecting an engine, only a portion of
the lights in a room would turn off.
18 AWG (1mm) cable installations will be wired as with category cable, except that each 18AWG cable
pair will be terminated with a
Redwood
RJ45-18AWG terminator. These terminators will allow the
18AWG pair to be connected to the RJ45 jack with no
other modifications required. Multi-pair 18AWG
can be used with multiple
Redwood
RJ45-18AWG terminators attached.
The
Redwood
engine, director, sensors, gateways and wall switches are designed for commercial use
only and are not for residential use.
