TECP-91-008 • Rev C • January 2019
Page 16
© 2019
CommScope
. All Rights Reserved.
4.5
Installing Trunk Cables
Trunk cables (“trunks”) are installed from the rear of the panel. The rear cover must first
be removed. Trunks should be installed from bottom up. Cables may be routed to the
panel from either side or from both sides.
Figure 16. Cable Bundled With Hook-and-Loops
Use the following procedure.
1. Remove the rear cover by loosening the captive fasteners, as shown in
Figure 17
.
Figure 17. Removing the Rear Cover
Note:
The preferred trunks for the EHD panel are CommScope trunks with gland
adapters and standard breakout lengths.
Note:
Trunks entering through lower level entry points should be routed to the
lower level trays within the chassis and trunks entering through higher level entry
points should be routed to upper level trays within the chassis.
Note:
Hook-and-loops should be installed around bundles for each tray. Install
where bundle begins to spread out naturally due to routing lengths. See
Figure 16
FASTENER
26413-A
