4
4 Installation of OCM6 splitter
3.15 Apply the foam and secure the loose tubes together with the
two tie wraps. Select the fibers to be spliced to the inputs of the OCM6
splitters and cut them off
(do not cut the feeder side).
3.14 Mark the loose tube at marked position and shave the tube
(make sure that the unshaved part of the tube is long enough to be
able lift the tray).
3.16 Store the unused fibers into the tray as shown.
4.1
Install the OCM6 splitter. Up to the three OCM6 splitters can
be installed.
4.2
Guide the input of the OCM6 splitter under the base plate
towards to the bottom tray.
