Page 2 of 8
© 2019 CommScope, Inc. All Rights Reserved
4.
Kit Contents
4.1.
Each BUDI box equipped with:
Description
1
Budi housing with pre-installed parts as shown *
2
Hose clamps (to secure feeder cable)**
3
Lugs (to secure feeder cable strength member)**
4
Felt tape (to secure the drop cable)
5
Foam (to seal the cable)**
6
Transportation tube 40’’’ ** ***
7
Tie-wraps (to secure drop cables and transportation tubes***)
* BUDI-M pre-term with 1x64 splitter shown below. Includes
a port assignment label located inside the box cover (see
picture in section 8.1).
** Splice configuration only.
*** Transportation tube only used if existing core tube need
to be replaced.
5.
Optional Accessories
(Sold Separately)*
5.1.
Grounding Kit for use with armored cable.
5.2.
Cable Skirts
Plastic and aluminum skirts are available in various sizes.
5.3.
Expansion Kits
Note:
The following item is for adding a second 1x32 splitter.
• 1x32 PnP Splitter Kit
*
See BUDI-M ordering information for additional accessories.
2 3
4
5
1
7
6.
Open the Box
6.1.
Rotate quarter turn fasteners counterclockwise to
unlock, pull bottom of cover away from base and lift off
cover.
7.
Mount the Box
7.1.
Place the base against the wall and mark the
mounting positions.
7.2.
Mount per approved local practice.
Please Note: Due to different local mounting practices, no
mounting hardware is provided with the box.
8.
Splice only application
8.1.
Feeder Cable Seal Preparation
8.1.1.
Locate the release pins from inside the box cover.
These pins are used to easily & quickly disassemble the
feeder cable entry plate to allow for feeder cable installation.
Note:
Release pin shown below.
6
