background image

2

Table of Contents 

Table of Contents..................................2

 

Safety Information.................................2

 

Warranty.................................................2

 

Limited Warranty

...................................

2

 

Pre-Installation ......................................3

 

Planning Installation

..............................

3

 

Tools Required

......................................

3

 

 

Hardware Included

..............................

3

Package Contents

...............................

4

Installation ..........................................5-6

 

Operation ...............................................6

 

Care and Cleaning.................................7

 

Troubleshooting....................................7

 

Safety Information 

When installing or using this LED light, basic safety 

precautions should always be taken including the 
following:

□ 

Read all instructions before installing this 
lighting system.

 

□ 

Save these instructions.

 

□ 

Do not mix old and new batteries.

 

□ 

Do not mix alkaline, standard (carbon-zinc), 

or rechargeable (Ni-Cad, Ni-Mh,
etc) batteries.

CAUTION: 

Do not install this product in a damp or 

wet location.

CAUTION: 

Do not install this product an in outdoor 

location.

CAUTION: 

Do not use chemical solvents or harsh 

abrasives to clean the fixture.

NOTICE

: The important safeguards and instructions appearing 

in this manual are not meant to cover all possible conditions and 
situations that may occur. It must be understood that common 
sense, caution and care are factors that cannot be built into any 

product. These factors must be supplied by the person(s) caring 
for, installing and operating the fixture. If you have any 
questions, please contact our Customer Service Team at 1-877-

527-0313 or visit www.homedepot.com.

Warranty 

LIMITED WARRANTY 

The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a period of 

three (3) years from date of manufacture. This warranty applies only to the original consumer purchaser and only to 
products in normal use and service. If this product is found to be defective, the manufacturer’s only obligation, and 
your exclusive remedy, is the replacement of the product at the manufacturer’s discretion, provided that the product 

has not been damaged through misuse, abuse, accident, modifications, alterations, neglect or mishandling. This 
warranty shall not apply to any product that is found to have been improperly installed, set-up, or used in any way 

not in accordance with the instructions supplied with the product. This warranty shall not apply to a failure of the 
product as a result of an accident, misuse, abuse, negligence, alteration, or faulty installation, or any other failure 
not relating to faulty material or workmanship. This warranty shall not apply to the finish on any portion of the 

product, such as surface and/or weathering, as this is considered normal wear and tear. The manufacturer does not 
warrant and specially disclaims any warranty, whether express or implied, of fitness for a particular purpose, other 

than the warranty contained herein. The manufacturer specifically disclaims any liability and shall not be liable for 
any consequential or incidental loss or damage, including but not limited to any labor/expense costs involved in the 
replacement or repair of said product.

Contact the Customer Service Team at 1-877-527-0313 or visit www.HomeDepot.com

.

Summary of Contents for MAGIC-L21-12

















Reviews: