9
Installation (continued)
☐
Loosen the screw on the swivel portion
of the knuckle (B), adjust the fixture to a
suitable orientation, and then tighten the
screw.
☐
Test the fixture by restoring power to the
breaker and light switch. Verify that the light
fixture illuminates. Adjust the light angle
as needed.
Swivel Knuckle Flood Mount
Plug unused
holes, if any
10
Adjust the lamp head
and test
Use the hand screw
here to adjust the
orientation
Seal around
hole
B
Use the hand screw
here to adjust the
orientation
(fig 20).
(fig 21).
(fig 22).
9
Seal with caulking
NOTICE:
Failure to properly caulk around the back face of the
light fixture and mounting surface could lead to water damage
and is not covered under warranty.
☐
For recessed junction box mounting, caulk
around the back face of the light fixture
shown in (fig 20) with silicone sealant (not
included).
☐
For surface mount junction box applications, caulk
between the junction box and mounting plate with
silicone sealant (not included) as shown in (fig 21).
