Auto-dialler mode
G8-IAX / G3-IAX
22
3.0/0616
Incoming call to the Intercom system
Initiate call
From the VoIP phone, a call to an Intercom station can be built up by means of the respective dial prefix
(
) or other functions can be carried out in the Intercom Server.
Example – dialling to Intercom station “103”:
If a password is defined, this code has to be dialled right after the dial prefix:
A call from a VoIP phone to the Intercom system is built up via the 1st channel of the Gx-IAX card. If
this channel is busy, the next idle channel is used automatically (
see “Dynamic channel allocation”
). For this reason, it is recommended to define the same password for each channel of a
Gx-IAX card.
End conversation
End conversation by pressing the button “#” at the telephone or by pressing the button
X
at the In-
tercom station.
After the conversation has been ended, the connection to the Intercom system stays upright for a
configurable time. During this time, a new conversation can be built up or other functions can be car-
ried out in the Intercom Server.
Prefix
Call number Intercom station
Dialling at VoIP phone
20
103
20103
Prefix
Password
Call number Intercom station
Dialling at VoIP phone
20
00
103
2000103
NOTE: Dialling
The dialling will be carried out after a short delay by default. By means of pressing the button “#”,
“SEND” or “DIAL” (depending on the brand), dialling will be carried out immediately.
