G8-S0/G3-S0-I
Telephone Interface
1.1/1010
33
General Telephone Functions
Initiate Dialling of
0
at Incoming Calls
For an call from the telephone to the Intercom system, it is possible to configure, that button
0
(at the
respective called station) is dialled automatically. This feature can be used e.g. in combination with the
following Intercom functions:
Call Request to a Central Control Desk
(the call lasts until it is taken over)
Triggering of the Direct Dialling function
(e.g. call to a station, initiation of a predefined conference etc.)
Configuration CCT 800
Interfaces > S0 >
tab
Common
Activate the checkbox
Dial 0 at incoming call
for the telephone interface.
For configuration of call requests and direct diallings, see current version of the manual “PRO 800”.
DTMF After-Dial Mode
In standard (in PABX mode), 8 seconds after entry of the last digit of the respective telephone number,
the after-dial mode is switched automatically from DTMF dialling to “Intercom dialling” (i.e. possibility
for after dialling in the Intercom system).
Note:
But via dialling
77
, it is possible to activate the DTMF dialling mode again, see also
Dialling of 0 at Incoming Calls” on page 33
Via configuration in CCT 800 it is possible, to deactivate the possibility for after dialling in the Intercom
system – i.e. the after-dial mode is switched fix to DTMF dialling.
Configuration CCT 800
Interfaces > S0 >
tab
Common
Activate the checkbox
Fix DTMF After-Dial Mode
for the telephone interface.
Blocking Incoming Calls
It is possible to block calls from the telephone net to the Intercom system.
Configuration CCT 800
Interfaces > S0 >
tab
Common
If the checkbox
No hook-off at incoming call
is activated, it will not be possible to call from a tele-
phone over the telephone interface, into the Intercom system.
