Commell P3WMA Series, User Manual, Page: 27 / 34

The frequency mapping table of the elements:
Ext. frequency PCI DIMM
66Mhz 33Mhz 100Mhz
75Mhz 37.5Mhz 112.5Mhz
83Mhz 41.6Mhz 124.9Mhz
100Mhz 33Mhz 100Mhz
105Mhz 35Mhz 105Mhz
114Mhz 38Mhz 114Mhz
120Mhz 40Mhz 120Mhz
124Mhz 41.33Mhz 124Mhz
133Mhz 44.33Mhz 133Mhz
Notice :
The 75, 83, 105, 114, 120, 124 and 133Mhz frequency are over specification.
You must install 8ns or faster DIMM on board if you set 105, 114, 120 or 124 Mhz as external frequency and
must install 7ns or faster DIMM on board if you set 133Mhz as external frequency.
Warning : Over specification operations are not recommended.
3.10 Load Fail-Safe Defaults
This loads the troubleshooting default values permanently stored in the ROM chips. These settings are not
optimal and turn off all high performance features. You should use these values only if you have hardware
problems. Highlight this option in the main menu and press <Enter>. The message below will appear.
Load Fail-Safe Defaults (Y/N)?N
If you want to process, type <Y> and press <Enter>. The default settings will be loaded.
3.11 Load Optimized Defaults
This feature loads optimized setting from the BIOS ROM. Use the default values as standard values for your
system. Highlight this option in the main menu and press <Enter>. The message below will appear.
Load Optimized Defaults (Y/N)?N
Type <Y> and press <Enter> to load the Setup default values.
3.12 Set Supervisor/User Password
You can assign, modify, or cancel password settings. To modify, highlight "Set Supervisor Password" or "Set
User Password" and press the <Enter> key. The screen will prompt you ("Enter Password"). Enter your
password. The maximum size of the password is 8 characters. System will prompt you to reenter the password
to verify. Remember the passwords are case sensitive.
If you want to remove the passwords, either delete passwords or press <Enter> when prompting for new
password.
If you want it to require password upon initial system startup and upon entering the CMOS Setup Utility, you will
need to change
the selection of the (Security Option) under (Advanced BIOS Features ) to "System".
If the setting is "Setup", the system will only require the password you activate CMOS Setup Utility.
3.13 Save & Exit Setup
When all the changes have been made, highlight "Save & Exit Setup" and press <Enter>. The message below
will appear:
Save to CMOS and Exit (Y/N)? N