Commell LV-67D, User Manual, Page: 48 / 50

LV-67D User’s Manual
-
47
-
Appendix D <Programming GPIO’s>
The GPIO can be programmed with the MSDOS debug program using
simple
IN/OUT commands.The following lines show an example how to do this.
GPIO0…..GPIO7 bit0……bit7
-o 2E 87 ;enter configuration
-o 2E 87
-o 2E 29
-o 2F 40 ;enable GPIO function
-o 2E 07
-o 2F 07 Select Logic Device 7
-o 2E F0
-o 2F xx ;set GPIO as input/output; set ‘1’ for input,’0’for
output
-o 2E F1
-o 2F xx ;if set GPIO’s as output,in this register its value
can be set
Optional :
-o 2E F2
-o 2F xx ; Data inversion register ; ‘1’ inverts the current
valus of the bits ,’0’ leaves them as they are
-o 2E 30
-o 2F 01 ; active GPIO’s
For further information, please refer to Winbond W83627THF datasheet.