Commax CNV-2M03RS, User Manual, Page: 11 / 23

IR Indoor Mini Dome Network Camera
User Manual
3
Device Installation
6
To avoid the impact of humidity, after installing the device, power on the device for at
least half an hour before sealing the cover.
3.2 Installation Mode
The IR Indoor Mini Dome Network Camera can be installed in ceiling mounting or
side wall mounting mode. In general, it is used in an indoor or building environment,
but can also be used in an outdoor environment. Figure 3-1 shows the ceiling mounting
mode. The side wall mounting mode is similar to the ceiling mounting mode.
NOTE
To achieve a good angle of view, you are advised to install the device in the place whose
vertical distance from the ground is about 3 m to 6 m.
Figure 3-1 Ceiling mounting mode
The ceiling mounting procedure is as follows:
Step 1
Unfasten the two torx screws on the cover of the mini dome by using the T15
combination wrench in the accessory package and open the cover upward, as shown in
Figure 3-2.
Open the cover gently and pull out the MIC line from the MIC socket, be careful not to snap
the MIC line.