4
2. Product Usage
●
Visitor Call
1. When a visitor presses the “Call” button on the door camera installed at the entrance, the
monitor rings a chime bell and shows the visitor. At this time, the monitor LED will blink.
2. When the visitor is shown, press the “Talk” button to have a conversation.
3. When finished with the conversation, press the “Talk” button again to cancel the screen and
to end the operation.
4. While in talking with the visitor, press the “Open” button to open the door.
●
Talking to the Interphone
1. First press the “Talk” button on the monitor and then press the interphone call button
“INT”.
2. The signal will be sounded and the interphone LED will blink. When responding to the
interphone, it can be made accordingly.
3. When you have a call from the camera at the time that the monitor and interphone are busy,
the monitor LED will blink and a 3-way talk among monitor, interphone and camera is
made possible for 90 seconds.
●
Monitoring
1. When the camera is connected to the monitor, press the monitor button “MON” and you
can check the camera video anytime you want.
2. A maximum of 2 cameras can be connected and the screen is switched to the camera-1,
camera-2, and standby mode by pressing the button.
3. When turning on the power, the monitor LED will blink in RED for 2 seconds while going
through the preparation process. Please don’t turn off the power since it is not an error.
When completed with the preparation process, the LED turns to GREEN and the system is
switched to the standby mode.
CDV-50A-8p 2006.8.10 2:32 PM 페이지4
