JULY. 19. 2002
560A
6
3. The engine will run until the pre-programmed time elapsed or shutdown input is received.
E. TIMER START:
This unit can be programmed to start and run the engine every 3 hours. The engine will run for the
programmed run time and then shut down.
IMPORTANT
: Timer Start should be used only in open areas, Never start and run the vehicle in on
enclosed space as a garage or carport.
3 hours timer start:
This feature is design for an extreme cold climate usage. The system will auto start
the vehicle every 3 hours, to prevent engine freezing and hard to start. A MAXIMUM OF SIX CYCLES CAN
OCCUR.
ENTER:
1. Press the
button to remote start the vehicle. As soon as the vehicle is running and the parking light
have turned on or flashing.
2. Immediately depress the
button then depress the
button. The parking light will flash (3) times.
The siren or horn chirps (3) times. The vehicle is now programmed to start every (3) hours.
3. Press the brake pedal to stop the vehicle running.
Exit the timer start:
Timer start can be exited manually as follows:
1. Make sure the remote start system is not operating the engine.
2. Turn the ignition on. The LED and parking light will flash (4) times. The siren or horn chirps (4) times.
Or
1. Press the button to remote start the vehicle. As soon as the vehicle is running and the parking light
have turned on or flashing.
2. Immediately depress the
button then press and hold the
button for 2 seconds. The parking
light will flash (4) times. The siren or horn chirps (4) times. The vehicle is no longer programmed to start
automatically.
F. SHUT-DOWN INPUT FOR REMOTE STARTER:
If any of the following conditions exist while the system is operating, the engine will not start or will shut
down immediately:
1. The hood is opened.
2.
The brake pedal is pressed.
3. Move the optional remote start enable toggle switch to OFF position. (If installed)
4.
Engine is over-revved. {“Tachometer checking type” only}
5.
The pre-programmed run time (5 /10 / 20 / 30 minutes) has elapsed.
6.
Transmitter
button is pressed.
7.
The vehicle refused to start running after {3} unsuccessful attempts.
G. DISABLING THE REMOTE START SYSTEM:
(If installed)
This feature allows your system’s remote start unit to be temporarily disabled to prevent the vehicle from
being remote started accidentally. This feature is useful if the vehicle is being serviced or stored in an
enclosed area. To disable the remote start, move the optional remote start enable toggle switch to the OFF
position.
