Compact Scaler Switcher
Comm-Tec S.r.l.
19
www.comm-tec.it
⚫
No Signal Timeout:
Set the auto power off time that the display device will
automatically power off after no signal is detected and the setting time is up.
⚫
Baud Rate:
Supports 9600, 19200, 38400, 57600 or 115200.
⚫
Command Format:
The default command format is ASCII, and
HEX
can be
selected.
⚫
Command Ending:
NULL, CR, LF or CR+LF can be chosen.
⚫
Display Off:
Type RS232 command to turn off display device, and then click “Save”.
Select “x2” to send the command two times.
⚫
Display Offx2 Delay:
Set the delay time of sending the Display Off command again,
and then click “Save”.
⚫
Display On:
Type RS232 command to turn on display, and then click “Save”.
⚫
Input Delay:
Set the delay time in seconds between the “Display On” and “Display
Input Select” commands.
⚫
Display Input Select:
Type the RS232 command to select the current input source
of switcher for the display device.
⚫
Trigger: “Display On” -> Wait “Delay” ->Send “Display Input Select”.
6.4.
Resolution Tab
⚫
Select the output resolution for HDMI and HDBaseT outputs.
⚫
Select “Auto for Rx” that the output resolution follows the display device.
