Comm Net Systems TPA 250 Fuse Panel Series, Setup And Operation Manual

Page: 12 / 28

TPA 250 FUSE PANEL
SETUP AND OPERATION MANUAL
PAGE 6 - INSTALLATION
WARNING
FAILURE TO REINSTALL THE INPUT SAFETY COVERS
WILL CREATE AN ELECTRICAL HAZARD.
Included with each TPA 250 series fuse panel are (4) input safety covers which are
designed to help isolate the input terminations.
Step 1.
Align the notch found on the included plastic safety covers with the slots
located at the rear of the panel.
Step 2.
Firmly insert into place until fully seated (see Figure 10) .
4.6 Output Connections
CAUTION
y
DO NOT PERFORM THIS STEP ON
CIRCUITS WITH FUSES INSTALLED.
y
ENSURE NO POWER IS PRESENT ON THE CIRCUIT
bEING WIRED bEFORE PROCEEDING.
NOTICE
SEE APPENDIX C ON PAGE 18 FOR TERMINAL SPECIFICATION
AND CAbLE WHIP ORDERING INFORMATION.
There are (12) positive latching DC connector positions for the output circuits found
on the TPA 250 fuse panel, available in either 40A or 100A connector configurations.
Cable whips are available in a variety of lengths and wire gauges. Contact Comm/net
sales for cable whip ordering information. Refer to the front of the panel for the circuit
mapping card for circuit mapping information.
Step 1.
Insert the DC plugs into the output receptacles until they click. The connectors
are keyed to ensure correct polarity (see Figure 11) .
Figure 10. Safety Covers
Figure 11. Output Connections
(40A Version Shown)