Comfy Go Mobility
Email: [email protected],
Tel:+1 844 755 5055
10
4. Sit on the chair and Lean backwards to make sure the clip locker which located below the seat to the
rear of the PHOENIX Power Wheelchair, to lock the seat into place. This step is very important !!!
5. Install the controller into the open slot on the arm of the chair, on the right side (if user needed, can
change to left side). tighten knob located under the armrest to secure the controller in place.
6. Connect the controller wire harness to the CPU wire harness. Take care the line up the pins properly
as arrow tip indicate, so that they do not get bent, broken or damaged.
