COMFORTPOOL EasyHeat 2, User And Service Manual

Page: 24 / 32

24
Attention!
Ensure the power plug is
secure.
If the plug is not secure, it may
cause an electric shock, over-
heating or fire
Never pull out the power plug
during operation.
Otherwise, it may cause an
electric shock or a fire due to
over-heating.
Never use damaged electric
wires or unspecified
electric wires.
Otherwise it may cause an
electric shock or a fire.
After all connections have been made and checked, carry out the following procedure:
1. Switch on the filter pump. Check for leaks and verify that water is flowing from and to the swimming
pool.
2. Connect power to the heat pump and press the On/Off button on the electronic control panel. The
unit will start up after the time delay expires (see below).
3. After a few minutes, check whether the air blowing out of the unit is cooler.
4. When turn off the filter pump, the unit should also turn off automatically.
5. Allow the heat pump and the filter pump to run 24 hours a day until the desired water temperature is
reached. The heat pump will stop running at this point. After this, it will restart automatically (as long as
the filter pump is running) whenever the swimming pool water temperature drops 1 degree below the
set temperature (for example, if you set the temperature 28°C, the heat pump will stop when the
temperature at 28°C. While it will restart when the temperature of the water down to 26°C).
Depending on the initial temperature of the water in the swimming pool and the air temperature, it may take
several days to heat the water to the desired temperature. A good swimming pool cover can dramatically
reduce the required length of time.
Time delay - The heat pump has a built-in 3-minute start-up delay to protect the circuitry and avoid excessive
contact wear. The unit will restart automatically after this time delay expires. Even a brief power interruption will
trigger this time delay and prevent the unit from restarting immediately. Additional power interruptions during
this delay period do not affect the 3-minute duration of the delay.
4.5. Condensation
The air drawn into the heat pump is strongly cooled by the operation of the heat pump for heating the pool
water, which may cause condensation on the fins of the evaporator. The amount of condensation may be as
much as several litters per hour at high relative humidity. This is sometimes mistakenly regarded as a water
leak.