FIREPLACE INSTALLATION
Figure 26 - Blower Model BK
Magnetic
Strips
Exhaust
Port
Screw
Green
Ground
Wire
Spade
Terminals
Side View
Lower Firebox
Cavity
Blower
Location
CHECK GAS TYPE
Use proper gas type for
fireplace
unit you are
installing. If your gas supply is not correct, do
not install
fireplace.
See retailer where you
purchased
firepla
ce for proper
fireplace
ac-
cording to your gas type or to purchase gas
conversion kit (see
Accessories
, page 37).
I
NSTALLING OPTIONAL BLOWER
ACCESSORY
NOTICE: If installing blower in
an existing
fireplace
with gas
connections,
shut off gas
sup
-
ply
and
disconnect
heater from
gas
supply
.
Contact
a
qualified
service person to do this.
WARNING: If there is a
dupl
ex
el
ectr
i
ca
l outlet installed in the
right side of the bottom of the
fi
re
place
base area
,
be sure that
the el
ectr
i
ca
l
pow
er to the outlet is
turned off before
p
ro
cee
ding with
blower installation. Failure to do
this
may
result in serious injur
y
.
Model BK Installation
Follow all instructions provided in blower
accessory kit.
1. Attach power cord to blower motor by
firmly
pushing two female terminals at end
of power cord onto two spade terminals
on blower motor (see Figure 26).
2. Attach green ground wire from power cord
to blower housing using screw provided
(see Figure 26). Tighten screws securely.
3. Place blower against lower rear wall of
firebox
outer wrapper with exhaust port
directed upward. Blower will
fit
inside back
opening and be held in position against
back wall by magnets (see Figure 26).
