comfortel M-710, Instructions Manual

Page: 31 / 120

Initial Commissioning
COMfortel M-710 - Instructions V01 06/2021
31
Note: The rechargeable batteries might warm up during charging. This is
not dangerous. For technical reasons, the charging capacity of the
rechargeable batteries reduces over time.
The Setup Assistant runs immediately, when the handset is connected to a
power source.
Selecting a display language
The language setting display is displayed. The set
language (e.g. English ) is marked.
1. Press until the required language, e.g. Français ,
is marked in the display.
2. Press the right-hand key directly under the display to select the language.
3. Exiting the menu: Press
for a long time.
If you need to display the menu again, do this:
1. Press the middle of the control key .
2. Slowly press
and , one after the other.
Registering the handset for the first time
These instructions describe how to register the telephone on a COMfortel WS-
500S or COMfortel WS-500M base station for the first time.
Requirements:
• The handset has been configured in the base station
•
Registration has been triggered in the base station.
Note: You can configure the base station manually or by provisioning via
the PBX. Please refer to the base station Operation Guide for instructions.
Note: You can find out the handset's IPUI, or scan it in, in the battery
compartment or on the packaging label. Alternatively, you can view the
IPUI on the display. To do so, press the centre of the control key to
display the menu, In it, enter *#06# . You will see the IPUI in the first line.
Example: 1: 029E74A560.
When you first commission the handset, the message Please register
handset is displayed when you select the language.
•
Select
Register
on the handset, to confirm the
Please register handset
prompt.
The system displays a clock symbol and the message
Searching for a
base in registration mode .
Deutsch
English
Français