3
3
www.comfortzoneproducts.com
PARTS IDENTIFICATION
ASSEMBLY INSTRUCTIONS
Fan Head Assembly:
Step 1:
Set the back grille on the motor shaft. Make sure that the internal
molded arrow (Fig. 1a) points up and the 4 clips fit properly. Push
firmly in order to fit them tightly (Fig. 1b). Make sure they are
secure.
Step 2:
Using a Philips-head
screwdriver, screw the
3x8mm screew with
washer top
(included
in the parts kit) into the
cylinder-shaped housing
at the top of the grille
(Fig. 2).
Step 3:
Set the fan blades on
the shaft of motor body
and screw the blades
nut toward the word
"THIGHTEN" as the
arrows show (Fig. 3).
Step 4:
Place the front and back
grilles together by aligning
the 6 clips, pushing firmly
until a "click" sound is
heard. (Fig. 4a, 4b).
Step 5:
• Take the
M3mm nut
(from
the parts kit) and place it on
the hex socket at the bottom
of the rear grille. (Fig. 5a)
• Next, take the
M3x20mm
screw
(from the parts kit)
and place it on the socket at
the bottom of the front grille.
(Fig. 5b)
• Secure the screw to the
nut to ensure the firm grip of
both grilles using a Philips-
head screwdriver.
Fig. 1a
Fig. 1b
Fig. 2
Fig. 4b
Fig. 4b
Fig. 3
Clip
Nut
Screw
Fig. 5a
Fig. 5b
1
2
6
8
7
3
9 10
12
11
14
15
13
17
18
19
4
5
5
21
3
16
20
1. Front grille
2. Rear grille
3. Grilles’ clips
4. ST 3x8mm Screw
with washer top:
(secures rear grille
to motor cover)
5. M3x20 Screw
and M3 Nut
(secure grilles'
interlock)
6. Fan blades
7. Blades nut
8. Motor shaft
9. Motor body
10. Oscillation switch
11. Pilot / Night light
12. Operation/Speed
control panel
13. Fan-to-pole fixing
knob
14. Telescopic pole
15. Height fixing ring
16. Telescopic tube
17. Fan base
18. Counterweight
19. Washer
20. L- screw
21. Wall fan support
bracket
