3
3
www.comfortzone-us.com
CZTFR1 (white) / CZTFR1BK (black)
Usage:
Fan Operation:
Always operate the fan in the upright position
following all instructions and recommendations listed in this
manual.
Fan Location:
Place the fan in the area of the room that will
provide proper fan cooling.
Fan Connection:
Plug fan directly into 120 volt A.C., 60 Hz
wall outlet. Be sure plug fits tightly in outlet. A loose connection
may cause overheating and damage to the plug or fan.
Note:
To prevent overloading a circuit, do not plug the fan into
a circuit that is servicing other electrical needs.
Turning Fan On/Off:
Place fan on stable level surface. Plug
fan into proper polarized outlet. To start the fan press ON/OFF
button. Press ON/OFF button again to turn fan off. Unplug fan
when not in use.
Fan Speed:
Press SPEED button to desired fan speed
(1, 2 or 3).
Oscillation Feature:
This fan can oscillate from side to side for
full room coverage. To use this feature press the SWING button
on the Control Panel while using any fan speed or while using the
timer function.
Timer Feature:
The timer function is designed to work using
oscillation or any fan speed. With a fan speed chosen press the
TIME button. Each time the TIME button is pressed additional
time duration lights illuminate. Simply add the value of the lights
and it is your set time. To turn the timer function off, press the
TIME button continuously until all the lights are off.
Fan Base Assembly:
Simple assembly is required to use
this fan.
1. Remove and save the pre-installed screws from the
underside of the fan, see Fig.1.
2. Assemble the two pieces of the base with power wire passing
through the center, see Fig. 2.
3. Place assembled base onto the bottom of the tower fan
and align the screw openings to the open screw holes from
assembly Step #1. Screw down base using screws saved
earlier.
4. Place wire through wire holders as shown in Fig. 4.
Remote Control:
Place 2ea. AAA size batteries in the remote
control. Use the buttons on the remote as you would with the top
control panel. Point the remote control towards the control panel
for the sensor to receive a signal.
Fig 1
Fig 2
Fig 3
Fig 4
