3
3
www.comfortzoneproducts.com
Turning Fan On/Off:
Place fan on stable level surface. Plug
fan into proper grounded outlet. To start the fan, press POWER
button ( ) repeatedly to desired fan speed: High, Med, Low
(
) Press POWER again and cycle through fan speeds to
«OFF» position to discontinue use. Unplug fan when not in use.
Oscillation:
To start fan oscillation, press Oscillation Control Knob
(located above motor housing) down. To stop oscillation function
pull Oscillation Control Knob up while the fan is in any oscillation
position.
Remote Control:
Place 2 «AAA» size batteries (not included) in the
remote control. Use the buttons on the remote as you would with the
control panel. Point the remote control towards the control panel for
the sensor to receive a signal.
Timer Feature:
The timer function is designed to work using
oscillation or any fan speed. With a fan speed chosen press the TIME
button on the control panel or remote control. Each time the TIME
button is pressed additional time duration lights illuminate. Simply
add the value of the lights and it is your set time. To turn the timer
function off, press the TIME button continuously until all the lights
are off.
Fan Assembly:
Simple assembly is required to use this fan.
USAGE
Fan Operation:
Always operate the fan in the upright position
following all instructions and recommendations listed in this manual.
Fan Location:
Place the fan in the area of the room that will provide
proper fan cooling.
Fan Connection:
Plug fan directly into 120 volt A.C., 60 Hz wall outlet.
Be sure plug fits tightly in outlet. A loose connection may cause
overheating and damage to the plug or fan.
Note:
To prevent overloading a circuit, do not plug the fan into a circuit
that is servicing other electrical needs.
Remote
Control
Receiver
Power
Level
Indicator
On/Off
Speed
Control
Time
Value
Indicator
Oscillation
Control
Step 4
Step 6
Remove the Blade Cap by twisting it
CLOCKWISE while holding the metal
shaft tightly.
Note: Threads are reversed.
Unscrew = Clockwise.
With locknut
removed,
assemble
Rear Grille
onto Motor
Housing. Rear
Grille should
fit into pins
on fan motor
housing as
shown.
Step 9
Step 11
Step 10
Place Pedestal Pole into Socket of
the fan base as shown.
With Base upside down, thread
Base screw through Base into
Pedestal Pole. Tighten securely.
Attach Front Grille to Rear
Grille with Hook Clip centered
on the bottom of the grille and
logo upright.
Press remaining Grille Clips onto
Rear Grille to securely attach
Front Grille. Do not operate fan
without Grille in place.
Thread Blade Cap onto
threaded end of Motor Shaft.
Note: Threads are reversed.
Tighten = Counterclockwise.
Step 1
Step 2
Step 3
With
thumbscrew
loosened,
pull Chrome
Extension
Pole out of
Fan Pedestal.
Pull
Chrome
Extension
Out
Set
Screw
Knob
Insert
Chrome
Extension
Pole into the
Fan Motor
Housing and
tighten Set
Screw Knob.
Step 5
Lo
o
s
e
n
Step 7
Locknut
Thread Locknut onto Motor
Housing to lock Rear Grille
in place.
Step 8
Remove any protective covering over
shaft before Fan Blade installation.
Place Fan Blade onto Motor Shaft.
Notice the pin on Motor Shaft should
fit into slots of Fan Blade.
Slot
Pin
Ti
gh
t
en
Hook Clip
CONTROL PANEL
Wire Handle
on Top
Pin
NOTE: The pedestal extension pole
may be recessed inside the larger
pole of pedestal body.
Note:
Wire Handle
should be on top.
