3
3
www.comfortzone-us.com
CZST161BTE / CZST161BTEBK
Usage:
Fan Operation:
Always operate the fan in the upright position
following all instructions and recommendations listed in this
manual.
Fan Location:
Place the fan in the area of the room that will
provide proper fan cooling.
Fan Connection:
Plug fan directly into 120 volt A.C., 60 Hz
wall outlet. Be sure plug fits tightly in outlet. A loose connection
may cause overheating and damage to the plug or fan.
Note:
To prevent overloading a circuit, do not plug the fan into
a circuit that is servicing other electrical needs.
Turning Fan On/Off:
Place fan on stable level surface.
Plug fan into properly grounded outlet. To start the fan, press
desired speed button: 1-LOW, 2-MED, 3-HIGH. Press 0-OFF to
discontinue use. Unplug fan when not in use.
Oscillation:
To start fan oscillation, press Oscillation Control
Knob (located above motor housing) down.
To stop oscillation function pull Oscillation Control Knob up while
the fan is in any oscillation position.
Fan Assembly:
Simple assembly is required.
Control Panel
On/Off Speed Control
Oscillation Control
Oscillation Control Knob
Step 3
Step 4
Step 9
Step 7
Step 5
Step 8
Step 6
With collar nut loosened,
pull Chrome Extension out
of Fan Pedestal
Assemble fan Control
Panel/Motor assembly onto
Chrome Extension and tighten
thumbscrew.
Remove any protective
covering over shaft before Fan
Blade Installation. Place Fan
Blade onto Motor Shaft. Notice
the pin on Motor Shaft should
fit into slots of Fan Blade.
Assemble Rear Grille onto
Motor Housing. Rear Grille
should fit into pins on fan
motor housing as shown.
Thread Blade Cap onto
threaded end of Motor Shaft.
Note: Threads are reversed.
Tighten = Counter-clockwise.
Thread Locknut onto Motor
Housing to lock Rear Grille
in place.
With logo upright, attach
Front Grille to Rear Grille by
snapping them together. Be
sure all 8 clips are secure.
Step 1
Step 2
Un-fold patented
Quad-Pod
®
base legs.
Place decorative Plastic Flange
over Extension Pole to cover
the base. Slide pedestal pole
into base receptacle. Tighten
nut to secure in place. Slide
flange over base connection.
On/Speed
Controls
Off
Control
Tighten
Pull
Chrome
Extension
Out
Thumb
Screw
Pin
Pin
Pin
Slot
Lock-Nut
