3
3
www.comfortzoneproducts.com
Installation Instructions
The wall fan must be mounted on 12 inch (300mm) thick dry and
cement - grouted firm wall or on 4 by 5 inch wood studs / joists.
Use wall bracket as a template for locating the holes
to be drilled.
After determining the hole locations, use an appropriate sized
drill bit and, drill holes through mounting surface.
It is recommended that a minimum of grade 5 fasteners be used.
The following are acceptable surfaces for mounting wall mount
assembly.
STEEL SURFACE
- When mounting to a steel surface, such as
vertical I-beam, drill through holes at pre-marked locations, using
a 9/32" drill bit. Attach wall mount assembly to mounting surface
using 1/4"-20 hex screw, in combination with 1/4" flat washers,
1/4" lock washers, and 1/4"-20 hex nuts.
MASONRY SURFACE
- When mounting to a masonry surface
use a 1/4" expansion type bolt or 1/4" masonry lag with shield.
Drill holes at pre-marked locations using appropriate sized drill
bit as recommended for fastener.
NOTE:
HARDWARE NOT SUPPLIED
Assembly Instructions:
USAGE:
Fan operation:
Always operate the fan in the upright
position following all instructions and recommendations listed
in this manual.
Fan location:
Place the fan in the area of the room that will
provide proper fan cooling.
Fan connection:
Plug fan directly into 120 volt A.C., 60
Hz wall outlet. Be sure plug fits tightly in outlet. A loose
connection may cause overheating and damage to the plug
or fan.
Note:
To prevent overloading a circuit, do not plug the fan
into a circuit that is servicing other electrical needs.
Speed control:
To operate the fan, each pull of the string
will cycle through the following settings:
• OFF
• LOW
• HIGH
• OFF
To Adjust Airflow Upward or Downward:
Loosen the position screw first and then loosen the pivot nut.
Tilt motor to the desired angle then firmly tighten the pivot nut
first and then tighten the position screw.
1. Install the wall bracket following Installation Instructions.
2. Install the fan motor on the angle support bracket.
3. Assembling the back guard, blade, font guard to the motor.
Wattage
Low
High
185W
250W
Voltage
120V
Frequency
60Hz
Max. Amperage
2.1A
Recommended Extension
Cord Gauge
16 AWG
Specifications
