3
3
CZHVP18EX
www.comfortzone-us.com
Usage:
Fan Operation:
Always operate the fan in the upright position
following all instructions and recommendations listed in this
manual.
Fan Location:
Place the fan in the area of the room that will
provide proper fan cooling.
Fan Connection:
Plug fan directly into 120 volt A.C., 60 Hz
wall outlet. Be sure plug fits tightly in outlet. A loose connection
may cause overheating and damage to the plug or fan.
Note:
To prevent overloading a circuit, do not plug the fan into a
circuit that is servicing other electrical needs.
Turning Fan On/Off:
Place fan on stable level surface. Plug
fan into proper grounded outlet. To start the fan, rotate Control
Dial from “0” (OFF) to desired fan speed (1, 2 or 3). Rotate top
Control Dial again to “0” (OFF) position to discontinue use.
Unplug fan when not in use.
Oscillation:
To start fan oscillation, press Oscillation Control
Knob (located above motor housing) down. To stop oscillation
function pull Oscillation Control Knob up while the fan is in any
oscillation position.
Fan Assembly:
Simple assembly is required to use this fan.
Step 3
Step 5
Step 7
Step 9
Step 4
Step 6
Step 8
Step 10
Step 1
Step 2
Assemble Extension Pole onto
Base by inserting 4 ea. 2-1/2"
bolts through openings.
Place decorative Chrome
Flange over Extension Pole to
cover the base screws.
Attach Front Grille to Rear
Grille with Hook Clip centered
on the top above Wire Handle.
Assemble Rear Grille onto
Motor Housing using screws
removed in Step 6. Tighten the
4 screws securely.
Take Fan Motor Housing and
insert it into Extension Pole
and tighten set screw securely.
Using washers and nuts
supplied, tighten Extension
Pole to Base as shown.
Thread Extension Pole Nut
onto threads of Extension Pole.
Press remaining Grille Clips
onto Rear Grille to securely
attach Front Grille. Do not
operate fan without Grille
in place.
Place Fan Blade onto Motor
Shaft. Notice the flat surface
on Motor Shaft. Tighten
set screw securely onto flat
surface on Motor Shaft.
Remove four mounting screws
from Motor Housing where
indicated to use for Rear Grille
in Step 7.
Set
Screw
Set
Screw
Flat
Surface
Wire
Handle
on Top
Hook Clip
