3
3
CZ161
www.comfortzoneproducts.com
Usage:
Fan Operation:
Always operate the fan in the upright position
following all instructions and recommendations listed in this
manual.
Fan Location:
Place the fan in the area of the room that will
provide proper fan cooling.
Fan Connection:
Plug fan directly into 120 volt A.C., 60 Hz
wall outlet. Be sure plug fits tightly in outlet. A loose connection
may cause overheating and damage to the plug or fan.
Note:
To prevent overloading a circuit, do not plug the fan into
a circuit that is servicing other electrical needs.
Turning Fan On/Off:
Place fan on stable level surface.
Plug fan into properly grounded outlet. To start the fan, press
desired speed button: 1‑LOW, 2‑MED, 3‑HIGH. Press 0‑OFF to
discontinue use. Unplug fan when not in use.
Oscillation:
To start fan oscillation, press Oscillation Control
Knob (located above motor housing) down.
To stop oscillation function pull Oscillation Control Knob up while
the fan is in any oscillation position.
Fan Assembly:
Assembly is required to use this fan.
Control Panel
On/Off Speed Control
Oscillation Control
Oscillation Control Knob
Step 4
Step 5
Step 8
Step 6
Step 7
Assemble Rear Grille onto
Motor Housing. Rear Grille
should fit into alignment pins
on fan motor housing as
shown. Note: Wire Handle
should be on top.
Thread Locknut onto Motor
Housing to lock Rear Grille in
place. Tighten=Clockwise
Remove any protective
covering over shaft before fan
blade installation. Place fan
blade onto motor shaft. Notice
the pin on motor shaft should
fit into slots of fan blade.
Thread blade cap onto
threaded end of motor
shaft. Note: Threads are
reversed at this connection.
Tighten=Counter‑clockwise.
With logo upright, attach
Front Grille to Rear Grille by
snapping them together. Be
sure all 8 clips are secure.
Do not operate fan without
grille in place.
Alignment Pins
Step 1
Step 2
Remove two (2) screws from
base of fan and save them for
Step #2
Place power cord wire through
opening of plastic fan base.
With cord opening properly
positioned, snap plastic
fan base onto fan body.
Re‑assemble screws removed
in Step #1.
Wire Goes
Through
Opening
and Guide
Screw
Screw
T
ig
h
ten
T
ig
h
ten
Step 3
Remove the Blade Cap by
twisting it CLOCKWISE while
holding the metal shaft tightly.
Note: Threads are reversed.
Unscrew = Clockwise.
Lo
o
se
n
