OPERATING THE IN-ZONE SENSOR
Displaying Zone Assignment
The zone assignment number can be displayed by pressing the
up
and
down arrows
at the same time for approximately 10 seconds. The device will reboot and display the
zone assignment for 2 seconds and then revert to current temperature display and
temperature setting options.
PRESS AND HOLD BOTH
ARROWS FOR 10 SECONDS TO
DISPLAY ZONE ASSIGNMENT
NUMBER.
CURRENT TEMPERATURE AND
TEMPERATURE SETTING
OPTION
ZONE ASSIGNMENT
Figure 5. Displaying Zone
Changing between Heating and Cooling Temperature Settings
1. If
heat and cool
option has been enabled for the specific zone at the
Comfort
Sync
thermostat, then
press
and
hold
both arrows simultaneously for 1 second
until either a red or blue light appears. Red light indicates heating temperature set
ting can be adjusted and blue light indicates cooling temperature setting can be
adjusted.
2.
Press
and
hold
both arrows again to change to the opposite setting (heating or
cooling).
PRESS AND
HOLD FOR 1
SECONDS
Figure 6. Toggling Between Heating and Cooling Temperature Setting
Changing Temperature Setting
Push either the
up
or
down arrow
to change the temperature setting.
INCREASE
TEMPERATURE
DECREASE
TEMPERATURE
Figure 7. Changing Temperature Setting
This display indicates the system
can operate automatically in either
heating or cooling modes. The left
arrow indicates that specific
temperature setting is enabled and
can be adjusted.
This display indicates the system
is in
AWAY
mode and zoning is
OFF. The arrows are disabled
when the system is in this mode.
This display indicates the system is
in
AWAY
mode. The touchscreen
can be used to adjust either heating
or cooling temperature settings
only.
This display indicates the system
zoning is OFF. The
Comfort Sync
logo is displayed.
When either the up or down arrow is
pressed, the up and down arrows will
illuminate
RED
to indicated the
heating temperature setting can be
adjusted. In addition, a left pointing
arrow will appear next to the
HEAT
TO
temperature.
This display indicates either the
In-Zone Sensor is attempting to
communicate or is unable to
communicate with the damper
control module or zone settings at the
Comfort Sync
thermostat are
incomplete. Check wiring to confirm
connections are correct.
NOTE - Zoning must be turned on at
the
Comfort Sync
thermostat.
A
B
C
D
E
F
G
When either the up or down arrow is
pressed, the up and down arrows will
illuminate
BLUE
to indicated the
cooling temperature setting can be
adjusted. In addition, a left pointing
arrow will appear next to the
COOL
TO
temperature.
Figure 8. Various In-Zone Sensor Displays
