Comfort Line Products
17
OPERATION
• Test the GFCI before each use. (Refer to the instructions
provided in the Maintenance section of this manual.)
• Plug into properly grounded receptacle.
• Do not use extension cords.
Temperature Control
1. During normal operation, the control
display on the top of the power pack
displays the current water temperature.
2. To set the desired water temperature, press
and release the up or down heat button.
Th e display will fl ash the desired water temperature set point. To change
the set point, press the up or down button once for each degree of water
temperature, to a maximum of 104ºF (40ºC).
3. After a few seconds pass without pressing either heat button, the display
will return to the current water temperature. Th e spa will begin heating
to the desired water temperature at a rate of approximately 1 to 1-1/2
degrees F per hour.
4. Th e spa is made to hold the set temperature. Do not lower the
temperature set point after use. Th e heater will turn on and off
automatically to maintain the desired temperature.
5. In case of electric power interruption, the spa temperature set point will
default to 100ºF when electric power is restored.
