-11 -
SERVICE INSTRUCTIONS
WARNING: Disconnect power
before attempting any
maintenance or cleaning to
reduce the risk of fire,
electrical shock or personal
injury.
REPLACING LIGHT BULBS
T
here are two (2) 40W Type B-10 light bulb located
under the log set bed. Remove the front glass
screen by unscrew the two screws on the top. Then
remove another two screws on the log ember. Take
out the ember to access dead bulbs.
CAUTION: The bulb in your unit
can become extremely hot.
Allow at least 15 minutes
between turning off the unit
and removing the light bulb to
avoid hot bulb coming in contact with the skin.
Loosen and remove burnt out bulb, and replace
with 40 W Type B-10 bulb.
MAINTENANCE OF MOTORS
The motors used on both blower fan and flame
simulator assembly are prelubricated for the
extended warranty of the motor, no further
lubrication is required. However, periodic
cleaning/vacuuming of the fan/heater unit is
recommended.
CAUTION: Even though the glass is safety glass it
may break if bumped, struck or dropped. Care must
be taken when handling the glass.
GLASS INFORMATION
1. Under no circumstances should this product
be operated with missing or broken glass.
2. Do not strike or slam the glass.
3. Do not use abrasive cleaners to clean the
glass.
CAUTION: Wait until the unit has completely
cooled before attempting any cleaning.
CLEANING
To clean the unit, first turn off controls on unit
and unplug unit from power source.
To clean the glass door: remove dust with
clean dry cloth or to remove finger prints and
other marks clean glass with clean damp cloth.
Do not use abrasive cleaners or spray liquids
on glass door surfaces.
Metal and metal painted parts should be
cleaned with clean damp cloth only. Do not use
abrasive cleaners or spray liquids on this
surface
WARNING: Do not exceed
40 Watts per light bulb.
Use of a higher rated bulb
may result in a fire
causing property damage
and personal injury.