Comfort Glow CCL3018NT, Owner'S Operation And Installation Manual

Page: 14 / 42

14 107123
VENT-FREE NATURAL GAS LOG HEATER
For more information, visit www.desatech.com
INSTALLATION
Continued
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
INSTALLING LOGS
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install these
logs exactly as instructed. Do not modify
logs. Only use logs supplied with heater.
1. Locate pegs on the bottom of back log
(#1). Slide these pegs into the holes in
the grate base behind the burner (see
Figure 18).
2. Place the base of the middle log (#2) in
the U-shaped slots of the grate base in
front of the back log. The cutout on the
right of the middle log should fit over the
burner (see Figure 19). Make sure the
front of the middle log is resting on the
tabs of the grate base and the cutout area
is centered over the burner “U” bend.
3. Locate the recesses on the back of the
front log (#3). Fit these recesses be-
tween the posts of the grate base (see
Figure 20).
Figure 18 - Installing Back Log (#1)
Figure 19 - Installing Middle Log (#2)
Figure 20 - Installing Front Log (#3)
Figure 21 - Installing Crossover Log (#4)
Peg
Hole in
Grate Base
Back Log (#1)
Burner
Cutout
Tab
U-Shaped
Slot
Middle Log (#2)
Crossover Log
(#1)
Notches
Rectangular
Knobs
“U” Bend
3
Front Log (#3)
Recess
Post
Post
Burner
CAUTION: After installation
and periodically thereafter, check
to ensure that no flame comes in
contact with any log. With the
heater set to high, check to see if
flames contact any log. If so, re-
position logs according to the
log installation instructions in this
manual. Flames contacting logs
will create soot.
Dual Burner Smoky Mountain
Oak Models
4. Locate the notches in the bottom of the
crossover log (#4). Place the crossover
log on top of the middle log and front
log. Make sure the notches of the cross-
over log lines up with rectangular knobs
on top of the middle and front logs (see
Figure 21).
5. Place lava rock around base of heater.
Do not put lava rock on logs on burner.