Comfort Bilt HP61, Operator'S Manual

Page: 9 / 35

9
SPECIFICATIONS
GLASS SPECIFICATIONS
This stove is equipped with ceramic glass.
Replace glass only with Qualified ceramic glass.
Model Number
BTU/Hour Output (1)
Heating Capacity (2)
Particulate Emissions
Efficiency
Power Consumption
Power Consumption
Fuel Storage Capacity
Exhaust Size
Width
Height
Depth
Weight
Exhaust center to floor
Exhaust center to side
Room Blower CFM
HP61
22,000-50,000
Up to 3,000 sq. ft.
1.211 g/hr
84%
520 Watts ignition
150 Watts operaton
51 lbs
3" Standard
24"
33"
27.5"
280 lbs.
12.5"
6.75"
142 CFM
WARNING
If you see black smoke at the end of the
exhaust/chimney, these are not normal emissions.
Check for clinkers or blockages in the burn pot.
Check for leakages around the stove, such as
glass door or ash pan.
Check for potential blockages in the exhaust
channels.
Check that the exhaust voltages are correctly set. 1.
2.
3.
4.
WARNING
(1) Heat output will vary depending on the brand,
type and quality of fuel, and the moisture content.
Consult your dealer for best results.
(2) Based on post 1982 home construction,
requiring 35 BTU/Hr. per Sq. Ft.
Emissions will vary, depending on the feed
level, burning time, and fuel. Consult your
dealer for best results.
Figure 1: Intake and exhaust positions
UNPACKING
Your stove will come fully assembled.
Remove all packing material and tape from the inside
of the firebox.
Remove any tape on the outside of the glass.
Open hopper, and remove all packing material and
power cord.
Note: Make sure the hopper is free of all forign matter
before filling with fuel. Forign material will cause auger
jams and will void stove warranty.
This stove has a manufacturer set minimum low
burn rate that must not be altered. It is against
federal regulations to alter this setting or otherwise
operate this stove in a manner inconsistent with the
operating instructions within this manual. If the unit
is modified, it will no longer be compliant with the
EPA regulations.