background image

This electric appliance produces infrared heat, and failure to follow 

.

This heater is designed for outdoor commercial use only.

READ AND SAVE THESE INSTRUCTIONS!

WARNING

FIRE OR EXPLOSION HAZARD

  Failure to follow safety warnings exactly could 

result in serious injury or property damage.

 

or liquids, including aerosol cans, in the vicinity of 

this heater while it is operating.

 

materials on or near the heater, or allow them to 

come in contact with the unit: rags, fabric, spray 

or aerosol cans, cleaning compounds, plastics 

or plastic containers, paper products, gasoline, 

  Do not install the heater close to furniture, curtains 

(1.8 meters) between all sides of the heater and 

  Do not cover or otherwise obstruct the heater. 

  Do not use heater without wire guard in place.

WARNING

PERSONAL INJURY HAZARD

  Do not touch the heater during operation. Burn 

or scald injury could result. The casing and 

components are extremely hot during operation.

  Keep children away from the heater. Never leave 

an unsupervised child near the heater.

  Because of injury risk, the heater should be 

operated only by individuals knowledgeable about 

the operation and familiar with the warnings and 

cautions listed in this manual.

  Because of injury risk, this heater is not intended 

for use by persons with reduced physical, sensory 

or mental capabilities.

  Heater is not for use in bathrooms, laundry areas 

or other locations where unit could fall into a body 

of water.

WARNING

PERSONAL INJURY HAZARD–SERVICE

  To avoid property damage, personal injury or death 

due to electrical shock, do not service the unit 

the wired circuits from the main power supply.

  Allow adequate time for the unit to cool down completely.

 

service technician.

  Do not use the heater if the power cord is damaged. 

electrician to replace the cord prior to use.

  Do not use heater if it has been dropped or dam-

aged in any way, until it has been inspected by an 

authorized service facility.

  When cleaning heater or replacing emitter, disconnect 

wired circuits from the power supply. Be sure heater 

and/or emitter has cooled completely, before handling.

WARNING

INSTALLATION & USE

To avoid property damage, personal injury or death 

due to electrical shock, follow all instructions in this 

Installation and Operation manual.

 

bottom and back of unit must be met. Failure to 

 

and must adhere to all local, state and national 

electric codes (NEC).

  Heater must be grounded and hard wired.

  Keep the power cable away from body of heater. 

Do not use heater if power cord is damaged.

  Do not insert or allow foreign objects to enter any 

of the heater openings. Electrical shock could 

result.

  Never leave the heater unattended while it is 

operating.

Installation & Operation 

Radiant Infrared Heater

 

WARNINGS

2

AITONS EQUIPMENT

Summary of Contents for IR30S









Reviews: