4
OPERATING INSTRUCTIONS
Check before turning on the device.
1. Check if the mains cable is in good condition.
2. The product adopts 220-240V AC power supply. Before use, confirm if the rated
current of the power socket meets the local requirements with safe grounding
device; otherwise, replace it with the qualified socket.
REMOTE CONTROL
Before using the appliance with the remote control, a coin cell battery (CR2032) must
be placed in the remote control. Follow the instructions below.
1
2
3
4
The remote control has a range of 5 metres.
the button functions are basically the same as on the operating panel.
Starting the appliance
Turn the power switch to “I” position, the power light
turns on. Press the ON/OFF
button (or the ON/OFF button on the remote controller) to start, the appliance supplies
air at high power after start and the display shows ”HI”.
Function setting
Repeatedly press the Function button; the heater cycles through ”high - low - ECO
mode - high”.
Temperature setting
In ECO mode, press the + or - button to set the temperature value in the range of
5 - 35°C. When the room temperature exceeds the set temperature by 2°C the device
stops working, and stays in standby mode. When the temperature is lower than the
set temperature, the device starts heating again.
Timer
Off-timer
During operation, press the TIMER button to enter the off-timer mode (0 - 8 hours),
then press the + button to increase the off-timer or press the - button to decrease the
off-timer.
On-timer
In standby mode, press the TIMER button to enter the on-timer mode (0 - 8 hours),
then press the + button to increase the on-timer or press the - button to decrease the
on-timer.
