Comet ORC13F2500R Owner'S Manual Download Page 7

4

WARNING: Risk of fire. Do not operate heater without wheel assemblies 

attached. Operate heater in upright position only (wheels on bottom, 

controls on top). Any other position could create a hazardous situation.

Ensure that the surface beneath the heater is clean and free of any 

obstructions. It is not recommended that this heater be placed on 

high-pile carpeting or any other surface that impedes the flow of air 

underneath the heater.

This heater include an a visual power indicator light  to warn that parts of 

the heater are getting excessively hot. If the power indicator light  flashes, 

immediately turn the heater off and inspect for any objects on or adjacent 

to the heater that may cause high temperatures. DO NOT OPERATE THE 

HEATER WITH THE POWER INDICATOR LIGHT FLASHING. 

1. Insert the plug into the suitable wall outlet.

    1) Never use the unit in place where is not even, make sure there is nothing 

        flammable or easy deform object within 1 meter (36 inches).

    2) Insert the plug after setting the thermostat to “MIN” position and setting the 

        power selected switches to “OFF” position.

    3) Do not cover the unit.

    4) The heater is suitable for operation on an A.C. electricity supply having the 

        same voltage as that show on its rating label.

2. Rotate power switch to the "Max" position then turn thermostat to the "high" 

    position, at this moment, the unit begins to work, when the temperature rises to

    which you are satisfied with, slowly turn the thermostat counter clockwise until 

    the power indicating light out, the room temperature can keep constant. If you 

    want to raise or lower the room temperature, you can either turn the thermostat 

    clockwise to raise the temperature or counter clockwise to lower the temperature, 

    or set the power switch to Low position.

3. After use, turn the power switch to the “OFF” position first, then turn the 

    thermostat to the “MIN” position, and pull out the power supply plug.

NOTES:

    1.The pilot lamp will be on only if the temperature is below the setting value of 

       the thermostat.

    2.The room must be sealed in good condition, if not, it will not make good result 

       because of the influx of heat.

    3.The outlets of the control chamber must be kept ventilative, if not, undue move 

       of the thermostat may occur.

OPERATING INSTRUCTION

Reviews: