32
Association). Every Ethernet device has a unique MAC (Media Access Control) address.
The MAC address is assigned at the factory and consists of six pairs of hexadecimal
characters, for example, 00:AA:BB:00:00:02. You need to know the MAC address of the
devices to configure this screen.
To change your router’s MAC filter settings, click Wireless LAN, MAC Filter to open the MAC
Filter screen. The screen appears as shown.
.
Active:
Select
Actived
to enable MAC address filtering.
Action:
Define the filter action for the list of MAC addresses in the MAC address filter
table.
Select
Deny Association
to block access to the router, MAC addresses not listed will be
allowed to access the router. Select
Allow Association
to permit access to the router, MAC
addresses not listed will be denied access to the router.
MAC Address:
Enter the MAC addresses (in XX:XX:XX:XX:XX:XX format) of the
wireless station that are allowed or denied access to the router in these address fields.
WEP
Key 1 to Key 4:
Enter the key to encrypt wireless data. To allow encrypted data
transmission, the WEP Encryption Key values on all wireless stations must be the same as
the router. There are four keys for your selection. The input format is in HEX style, 5 and 13
HEX codes are required for 64-bitWEP and 128-bitWEP respectively.
If you chose
WEP 64-bits
, then enter any 5 ASCII characters or 10 hexadecimal characters
("0-9", "A-F").
If you chose
WEP 128-bits
, then enter 13 ASCII characters or 26 hexadecimal characters
("0-9", "A-F").
You must configure all four keys, but only one key can be activated at any one time. The
default key is key 1.
WPA-PSK
