- 6/8 -
Recovery Procedures
Recovery Procedures
Recovery Procedures
Recovery Procedures
４．Press the CENTER key. An automatic adjustment process will begin; you will notice a number incrementing
upward.
６. Now turn the CA-500 MarkII off.
FAQ
–
Frequently Asked Questions
-
(Before Contacting Us)
Q.
Q.
Q.
Q. When the antenna connected,
When the antenna connected,
When the antenna connected,
When the antenna connected, the resonant frequency appears shifted or there is no SWR dip.
the resonant frequency appears shifted or there is no SWR dip.
the resonant frequency appears shifted or there is no SWR dip.
the resonant frequency appears shifted or there is no SWR dip.
A. On an antenna not requiring radials, the case of this unit is the
“
ground
”
and it is possible, due to
common mode current flow or other reasons, that the meter may be situated in a position that causes radically
unusual readings to occur. Try to relocate the meter as close to the antenna as possible to see if this
eliminates the problem.
If ER2 appears immediately aftger powering up the unit,
it means that the internal flash data is corrupted.
1．Press and hold in the GRAPH ON/OFF key; while holding it
in, press the POWER key to turn on the CA-500 MarkII.
・Release the GRAPH ON/OFF key when prompted.
・The version number for the unit’s firmware will; now appear
on the LCD.
2. Now press the GRAPH ON/OFF key.
[BAND A] will be displayed.
3．Press the GRAPH ON/OFF key again.
[AUTO: 1] will be displayed.
・Set the FREQ knob to the center of its range.。
・Do not move the FREQ knob hereafter during
this procedure.
5．After about two minutes, [COMP:
35 will be displayed. The procedure
is now complete.
All manuals and user guides at all-guides.com
