Comelit PLANUX MANAGER, Manual

Page: 53 / 80

53
ADVANCED
ADV
ANCED
1. Set the RS485 bus address
2. Set the RS485 bus speed
3. Set the device password
4. Set the user code
PLANUX MANAGER SETTINGS FOR
VEDO SERIES CONTROL UNITS
The settings required in order to use the Planux
Manager device with Vedo series control units are
illustrated below.
Access the menu Setup > Advanced > RS485 bus
address.
1
1 2 3 4 5
6 7 8
9 0
Thu 08/09/13 - 16:07 0W
This menu requires entry of the same RS485 bus
address as set on the Vedo series control unit in use.
Access the menu Setup > Advanced > RS485 bus
speed.
56700 56700
38400
115200 115200
9600
Thu 08/09/13 - 16:07 0W
This menu requires entry of the same RS485 bus
speed as set on the Vedo series control unit in use.
Access the menu Setup > Advanced > Device
password.
*
1 2 3 4 5
6 7 8
9 0
C
Thu 08/09/13 - 16:07 0W
This menu requires entry of the same password
as set in the "Device password" fi eld on the Safe
Manager software System Parameters menu (set by
default to 0).
Access the menu Setup > Advanced > User code.
*****
1
2 3 4 5 6 7 8
9 0
Thu 08/09/13 - 16:07 0W
This menu requires entry of a user code authorised for
control via Planux Manager (Safe Manager).
The areas managed by this user code must correspond
to those programmed on the Planux Manager monitor
(SimpleProg).