19
Email: Click Email, then it will send Email to appointed mailbox when alarm triggered
Snap: not used
Record: Click, it will do video record automatically when alarm triggered
Alarm Output: There is a warner connect the alarm output port, alarm triggered the embedded relay switch to make alarm output.
Snap count: not used
Snap Interval: not used
Enable PTZ: Click Enable PTZ, it will linkage PTZ operation when alarm input
Preset: set the linkage preset point
After all parameters setting completed, click “Save” and the it comes into effect immediately.
Alarm Out
Network High Speed Dome “Alarm Out” setting interface as figure 3-25.
Figure 3-25
Output Relay Status: Normally Open/ Normally Close selectable
Output Delay: Select the alarm output time( Alarm delay output when alarm triggered)
After all parameters setting completed, click “Save” and the it comes into effect immediately.
Exception Settings
Network High Speed Dome “Exception Settings” interface as figure 3-26.
Figure 3-26
Exception Type: Disk full/ disk fault/ network broken/ IP address conflict/ Illegal access/ video signal exception types selectable
