5
3
INSTALLING THE AUDIO MODULE
3.1
AUDIO MODULE SPEAKER
The operating voltage for the AUDIOMODULE Speaker is 24 V DC.
The power supply cables are now connected to the screw terminals (
Errore. L'origine riferimento
non è stata trovata.
). Attention must be paid to the correct
polarity
:
(Left: Plus (+), Right: Minus (-
)).
In order to connect the speakers and hi-fi system correctly, attention must also be paid here to the
correct
polarity
(Fig. 4):
( - Left + | - Right + )
Important note: Before you disconnect the power supply, please
shut down the DATA LOGGER via its web interface first
(Configuration/System)!
3.2
AUDIO MODULE LINE
The operating voltage of for the AUDIO MODULE Line is 10-32 V DC.
The power supply cables are now connected to the screw terminals (see
Errore. L'origine
riferimento non è stata trovata.
). Attention must be paid to the correct
polarity
:
(Left: Plus (+),
Right: Minus (-))
.
To connect active loudspeakers or hi-fi system used a 3,5mm jack plug and insert it into the "line-
out" socket.
The KNX bus cable is attached to the smaller 2-pole screw terminal, as shown on the front panel (as
shown below see
Errore. L'origine riferimento non è stata trovata.
).
Pay attention to the correct polarity!
(Left: Black (-), Right: Red (+))
.
The screw terminals can now be reinserted into the AUDIOMODULE.
If desired, you can now connect an external audio source, such as TV, CD-, DVD-Player, with a 3.5
mm jack plug to the “line in” socket (see
Errore. L'origine riferimento non è stata trovata.
).
The device can now be snapped onto the DIN rail complying with EN 60715.
NOTE: Set the AUDIO AMP, or your active speakers with built in amp, to a low volume setting
initially, and the AUDIO MODULE to a high volume level.
Gradually increase the volume level of the AUDIO AMP (or your active speakers) during the first
playback if needed, and store its final volume level.
This prevents you from accidentally destroying your speakers by starting your first playback at