6. See Setup Codes for Audio Devices to find the brand name of the audio device you want to control. Enter
the first five-digit code for your brand of audio device. If performed correctly, the green light under the
Power button blinks twice.
Note: If the green light emits one long blink, repeat steps 2 and 3, entering the same code.
7. Point the remote at the audio device and press the
Power
button. If the audio device turns off you have
found the correct code. If the audio device does not respond, repeat steps 2-4, trying each code listed for
your brand of audio device. If none of the codes work, see Searching for a Device Code below.
Programming Audio Control
The remote contains a universal audio library and can be programmed to operate the Power and Volume
controls of your audio device, such as an amplifier.
1. Turn on the audio device you want to control.
2. Press and hold the
Delete
button until the green light under the Power button blinks twice.
3. See Setup Codes for Audio Devices to find the brand name of the audio device you want to control. Enter
the first five-digit code for your brand of audio device. If performed correctly, the green light under the
Power button blinks twice.
Note: If the green light emits one long blink, repeat steps 2 and 3, entering the same code.
4. Point the remote at the audio device and press the
Power
button. If the audio device turns off you have
found the correct code. If the audio device does not respond, repeat steps 2-4, trying each code listed for
your brand of audio device. If none of the codes work, see Searching for a Device Code below.
Searching for a Device Code
If the brand of your TV or audio device is not listed in the code list, try searching for your code.
1. Turn on your TV or audio device.
2. Press and hold the
Delete
button until the green light under the Power key blinks twice.
3. Press
9 9 1
. The green light under the Power button blinks twice.
4. Press
1
to search for a TV, or press
3
to search for an audio device.
5. While pointing the remote control at the device, press and release
C
until the device turns off.
You may need to press C numerous times.
Note: In the search mode, the remote control sends IR codes from its library to the target device.
6. Press
OK/Select
to lock in the code.
If you have set up the remote control using this procedure, you may need to find out which five-digit code is
operating your TV or audio device. Perform the following steps after setting up your TV or audio device to find
out which five-digit code operates it.
1. Press and hold the
Delete
button until the green light under the Power key blinks twice.
2. Press
9 9 0
. The green light under the Power button blinks twice.
3. Press
1
to search for a TV, or press
3
to search for an audio device.
4. To view the code for the first digit, press
1
once. Wait three seconds and count the number of times the
green light blinks (e.g., three blinks =3) and write down the number in the TV Code or Audio Code boxes
below.
Note: If a code digit is “0”, the green light under the Power button does not blink.
5. Repeat step 3 four more times for the remaining digits. Use 2 for the second digit, 3 for the third digit,
4 for the fourth digit and 5 for the fifth digit. Finish writing down the code in the TV Code or Audio Code
boxes below.
TV Code
Audio Code
4
Programming Your Remote Control
