23
www.combisteel.com
Trouble Shooting Guide
Common problems may easily be solved, saving you the cost of a possible service call.
Please read carefully the instruction manual and revert to troubleshooting guide chart.
PROBLEM
POSSIBLE CAUSE
Steak Ager does not
operate.
Not plugged in.
The appliance is turned off.
The circuit breaker tripped or the fuse is broken.
Steak Ager is not cold
enough.
Check the temperature control setting.
External environment may require a higher setting.
The door is opened too often.
The door is not closed completely.
The door gasket does not seal properly.
Turns on and off
frequently.
The temperature in the cabinet is higher than conventional
The door is opened too often.
Storage overload in the cabinet
The door is not closed completely.
The temperature is not set correctly.
The door gasket does not seal properly.
The light does not work.
Not plugged in.
The circuit breaker tripped or a blown fuse.
The light is damaged.
The light is “OFF”.
Vibrations.
Please check whether the steak ager is on level ground
The Steak Ager seems to
make too much noise.
The rattling noise may come from the flow of the refrigerant, which is normal.
As each cycle ends, you may hear gurgling sounds caused by the flow of
refrigerant in your Steak Ager.
Contraction and expansion of the inside walls may cause popping and crackling
noises.
The Steak Ager is not level.
The door will not close
properly.
The Steak Ager is not level.
The door was reversed and not properly installed.
The gasket is faulty. ( magnet or rubber is spoiled)
The shelves are out of position.
Before disposal of the appliance
1. Disconnect the main plug from the main socket.
2. Cut off the main cable and discard it.
